Agilent Technologies ENA Series User Manual page 597

The line measurement is performed, and an asterisk appears at the
then a check mark [v] also appears on the
Step 12. Press the
Step 13. Connect the Line 2 standard between test ports 1 and 2 and press the
The line measurement is performed, and an asterisk appears at the
then a check mark [v] also appears on the
NOTE When the frequency ranges of the line and the match overlap, the data of the line is used in
the overlapped frequency area. When the frequency ranges of multiple lines overlap, the
data of the line measured later is used in the overlapped frequency areas.
NOTE Isolation calibration measurement is not available.
Step 14. When all of the necessary calibration measurements are completed, press the
Coef
correction is turned ON. In the calibration property display (ON/OFF with
Property
4. Closing macro
Press the
Multiport TRL/LRM calibration operating procedure
1. Selecting Test Port Select test ports (1 in Figure A-7). As shown in Figure A-7, 3- and
4-port TRL/LRM calibration can be performed with any combination of test ports.
NOTE For more information on starting a VBA macro, see "Operating Procedure" on page 586.
Figure A-7 Selecting test port
NOTE The TRL/LRM calibration VBA macro automatically detects the ENA's active channel,
and calibration is performed for the active channel. The macro does not perform calibration
for the ENA's inactive channels.
2. Defining Calibration Kit
Appendix A
button (6 in Figure A-6).
Line2
button (7 in Figure A-6). The calibration coefficient is calculated and the error
), the state is indicated by "F" (same as full n-port SOLT calibration).
button (8 in Figure A-6) to exit from the macro.
X
Manual Changes
[ ]Line1 1-2
button.
Line1
[ ]Line2 1-2
[ ]Line2 1-2
button.
Line2
Manual Changes
button and
button.
button and
Update Cal
-
[Cal]
591