Redefining A Calibration Kit - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Redefining a calibration kit

To change the definition of a calibration kit, follow the procedure below.

Defining a new calibration kit

1. Select the calibration kit to be redefined.

2. Define the type of standard. Select one from among the OPEN, SHORT, LOAD,

delay/THRU, and arbitrary impedance standards.

3. Define the standard coefficient.

4. Designate a standard class for the standard.

5. Save the data for the calibration kit that has been redefined.

Changing the pre-defined connector between male and female (e.g. OPNE (f) to OPEN

1. Select the calibration kit to be redefined.

2. Designate a standard class for the standard.

3. Save the data for the calibration kit that has been redefined.

Redefining a calibration kit

Step 1. Press

Step 2. Press

Step 3. Select the calibration kit to be redefined according to the list below.

If the names (labels) of calibration kits were changed prior to operation, the new names

will appear on the respective softkeys.

Selects the "85033E" calibration kit

Selects the "85033D" calibration kit

Selects the "85052D" calibration kit

Selects the "85032F" calibration kit

Selects the "85032B" calibration kit

Selects the "85036B/E" calibration kit

Selects the "85031B" calibration kit

Selects the "85050C/D" calibration kit

Selects the "85052C" calibration kit

Selects the "85038A/F/M" calibration kit

Selects the fourth user-defined calibration kit

Changing the Calibration Kit Definition

E5070b E5071b