Reading Values On The Trace - Agilent Technologies ENA Series User Manual

Reading values on the trace

You can read the value of a marker displayed on the trace.
In rectangular display format, the marker response value is always in the same data format
as that of the Y-axis. On the contrary, one format for the marker response values (two
values: main and auxiliary) can be selected from among several types. The selection is
performed in the data format.
Table 6-1 Marker Response Values for Smith Chart/Polar Data Formats
Softkey for selecting data
format
Smith
Smith
Smith
Smith
Smith
Polar
Polar
Polar
*1.Inductance or capacitance is also displayed.
For setting up data formats, refer to "Selecting a Data Format" on page 81.
Reading a Value on the Trace
Step 1. Press
Step 2. Press
Step 3. Press
NOTE At this point, marker 1 is turned on and becomes active (you can operate the marker).
When using marker 1, you can omit Step 4.
Chapter 6
Analyzing Data on the Trace Using the Marker
Marker response value
Main
- Linear amplitude
Lin / Phase
- Log amplitude
Log / Phase
- Real component
Real / Imag
- Resistance
R + jX
- Conductance
G + jX
- Linear amplitude
Lin / Phase
- Log amplitude
Log / Phase
- Real component
Real / Imag
or to activate the channel on which a marker is used.
or to activate the trace on which a marker is used.
.
Data Analysis
Auxiliary
Phase
Phase
Imaginary component
*1
Reactance
*1
Susceptance
Phase
Phase
Imaginary component
253