Figure 4-33
Connection of standards in 3-port TRL calibration
Operational procedure
NOTE
The shapes of actual standards differ from those shown in Figure 4-33 which are just
symbols for illustration.
Step 1. Press
calibration.
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. Press
Step 6. Select test ports for which you want to execute TRL 3-port calibration. (In the following
procedure, test ports you select here are expressed as test ports x, y, and z.)
Softkey
1-2-3
1-2-4
1-3-4
2-3-4
NOTE
An asterisk (*) in the upper right of the softkey indicates that a calibration coefficient exists
that will be cleared if you select the test port and execute acquisition of the calibration
Chapter 4
or
.
.
Calibrate
.
3-Port TRL Cal
.
Select Ports
Function
Selects test ports 1, 2, and 3.
Selects test ports 1, 2, and 4.
Selects test ports 1, 3, and 4.
Selects test ports 2, 3, and 4.
3-port TRL calibration
to select the channel for which you want to execute
Calibration
141