Set Up Bandwidth Test; Turning On/Off Bandwidth Test And Displaying Results - Agilent Technologies ENA Series User Manual

Limit Test
Bandwidth Test
•

Set up bandwidth test

You must set up the bandwidth threshold and the upper and lower limits before you can use
the bandwidth test function. You can specify the threshold, upper limit, and lower limit for
each trace.
Operational procedure
Follow the steps below to set up the bandwidth test.
Step 1. Press
bandwidth test function.
Step 2. Press
bandwidth test function.
Step 3. Press
Step 4. Press
Step 5. Press
Step 6. Press
Bandwidth
bandwidths.
NOTE
If the data format is Smith chart or polar, the limit test is performed for the main response
value among the two marker response values.

Turning On/Off Bandwidth Test and Displaying Results

You can configure the on/off setting of the bandwidth test function for each trace
independently.
Operational procedure
Follow the steps below to configure the on/off setting of the bandwidth test.
Step 1. Press
bandwidth test function.
Step 2. Press
bandwidth test function.
Step 3. Press
Step 4. Press
Step 5. Press
the screen by turning on
392
Status register (for further information, see the Programmer's Guide)
or
or
to display the Analysis menu.
to display the softkeys for the bandwidth test.
Bandwidth Limit
to specify the bandwidth threshold. The unit is dB.
N dB Points
to enter the lower limit for the bandwidth. Similarly, press
Min Bandwidth
to enter the upper limit for the bandwidth. The unit is Hz for both Min and Max
or
or
to display the Analysis menu.
to display the softkeys for the bandwidth test.
Bandwidth Limit
and turn on the bandwidth test. You can display the bandwidth marker on
BW Test
BW Marker
to activate the channel to which you want to apply the
to activate the trace to which you want to apply the
to activate the channel to which you want to apply the
to activate the trace to which you want to apply the
. To display the bandwidth value, turn on
Max
.
BW Display
Chapter 11