Using the Equation Editor
Measurement data (corrected data) can be calculated by creating a equation using the
equation editor.
The equation editor can create a equation label, too. The created equation label is displayed
on the measurement parameter area of the screen. For details, refer to "Entering the
equation label" on page 279
The following describes how to use the equation editor.
Procedure to start the equation editor
Step 1. Press
equation editor.
Step 2. Press
editor.
Step 3. Press
Step 4. Press
Procedure to use the equation editor
The following screen appears when starting the equation editor.
Figure 6-16
Equation editor
Chapter 6
or
or
to activate the trace for which you want to use the equation
.
.
Equation Editor...
Using the Equation Editor
to activate the channel for which you want to use the
Data Analysis
277