Agilent Technologies ENA Series User Manual page 411

Step 5.
Method
Softkey
Current Span
Active Marker
User Span
*1.Even if the active marker has been disabled, it is automatically enabled.
Step 6. If you have selected
value and a stop value.
NOTE
For
Current Span
Freq1
NOTE If the setting is not made before starting OPEN/SHORT standard measurement, it does not
affect the calculation result.
Figure 12-5 Frequency points in a frequency range (Freq1 and Freq2)
Chapter 12
to set the frequencies used for calculation.
Function
Executed using the frequency range set currently.
Executed using the frequency at the active marker.
is applied to Loss1. Loss2 is ignored.
Executed using a start value and a stop value you set.
, use
User Span
and , a frequency point at 1/4 of the frequency range is set to
User Span
; a frequency point at 3/4 of the frequency range is set to
Optimizing Measurements
Setting Port Extensions and Loss Values
and
User Span Start User Span Stop
Freq2
*1
In this case, the result
to set a start
. (See Figure 12-5.)
405