Stimulus Block; Floppy Disk Drive - Agilent Technologies ENA Series User Manual

Overview of Functions
Front Panel: Names and Functions of Parts

5. STIMULUS Block

A group of keys for defining the stimulus values (signal sources and triggers).

6. Floppy Disk Drive

A device for storing to and reading from a floppy disk the setup state of the
E5070B/E5071B, measurement data, calibration data, data on images displayed on the
LCD screen, VBA (Visual Basic for Applications) programs, etc. The floppy disk drive is
compatible with a 3.5-inch, 1.44 MB, DOS (Disk Operating System) formatted floppy
disk.
There is a floppy disk access lamp to the lower left of the floppy disk drive opening. When
the floppy disk drive is accessing a disk (for reading or writing), this lamp is lit green.
Pressing the disk eject button to the lower right of the floppy disk drive ejects the inserted
floppy disk.
NOTE Insert a floppy disk into the floppy disk drive opening right side up in the direction of the
arrow marked on the disk.
Do not press the disk eject button while the floppy disk access lamp is on. Trying to
forcefully pull the floppy disk out while the lamp is on may damage the floppy disk or disk
drive.
34
Displays the data entry bar for specifying the start value of
Key
the sweep range in the upper part of the screen. (It also
displays the "Stimulus Menu" on page 714 for specifying
the sweep range on the right side of the screen.)
Displays the data entry bar for specifying the stop value of
Key
the sweep range in the upper part of the screen. (It also
displays the "Stimulus Menu" in the same way as
Displays the data entry bar for specifying the center value
Key
of the sweep range in the upper part of the screen. (It also
displays the "Stimulus Menu" in the same way as
Displays the data entry bar for specifying the span value of
Key
the sweep range in the upper part of the screen. (It also
displays the "Stimulus Menu" in the same way as
Displays the "Sweep Setup Menu" on page 715 on the right
Key
side of the screen. Manipulating the "Sweep Setup Menu"
enables you to specify the signal source power level, sweep
time, number of points, sweep type, etc.
Displays the "Trigger Menu" on page 725 on the right side
Key
of the screen. Manipulating the "Trigger Menu" enables
you to specify the trigger mode and trigger source. You can
specify the trigger mode for each channel.
.)
.)
.)
Chapter 2