Setting Trace Display - Agilent Technologies ENA Series User Manual

Setting Measurement Conditions
Setting Channels and Traces

Setting trace display

Setting the number of traces
Depending on the measurement parameters of the traces displayed for each channel, the
sweep necessary for each channel is executed. For more information, refer to "Sweep
Order in Each Channel" on page 242.
You specify the trace display by setting the number of traces (upper limit of displayed trace
numbers). For example, if you set the number of traces to 3, traces 1 through 3 are
displayed.
The procedure for setting the number of traces is as follows:
Step 1. Press
number of traces.
Step 2. Press .
Step 3. Press
Number of Traces
Step 4. Press the desired softkey to set the number of traces.
Setting trace layout (graph layout)
Traces are laid out and displayed in the order of the trace number from graph 1 according
to the graph layout in the channel window.
You can select the graph layout from Figure 3-2.
If the number of traces is less than the number of graphs, nothing is displayed in the
remaining area. If the number of traces you set exceeds the number of graphs, excess traces
are superimposed from the first graph. For example, if you select
layout and set the number of traces to 5, graph 1 (Gr1 in Figure 3-2) and graph 2 (Gr2 in
Figure 3-2) display traces 1 and 4 and traces 2 and 5, respectively, by superimposing, and
graph 3 (Gr3 in Figure 3-2) displays only trace 3 as shown in the figure below.
64
or to select the channel for which you want to set the
.
as the graph
Chapter 3