Enabling/Disabling The Equation Editor; Entering The Equation Label - Agilent Technologies ENA Series User Manual

Enabling/Disabling the equation editor

The following procedure describes how to enable/disable the equation entered using the
equation editor.
Step 1. Press
equation editor.
Step 2. Press
aditor.
Step 3. Press
Step 4. Press
Softkey
ON
OFF

Entering the equation label

You can enter an equation label using the equation editor. After inputting, the measurement
parameter of the active trace is displayed on the screen as the equation label (Figure 6-17).
By entering the equation label and "=" prior to the equation, it is recognized as the equation
label.
For the procedure to start the equation editor, refer to "Procedure to start the equation
editor" on page 277.
NOTE A space is not available for the equation label.
The following figure is the example of the equation label, "myTr".
Figure 6-17 Entering the equation label
Chapter 6
or
or to activate the trace for which you want to use the equation
.
.
Equation
Function
Enables the equation editor.
Disables the equation editor.
Using the Equation Editor
to activate the channel for which you want to use the
Data Analysis
279