Internal Reference Signal Output Connector (Ref Out); Serial Number Plate; Certificate Of Authenticity Label; Rear Usb Port - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Overview of Functions

Rear Panel: Names and Functions of Parts

11. Internal Reference Signal Output Connector (Ref Out)

A connector for outputting the internal frequency reference signal from the

E5070B/E5071B. By connecting this output connector to the external reference signal

input connector of another device, the device can be phase-locked to the internal reference

signal of the E5070B/E5071B and used under this condition.

Connector type: BNC connector, female

Output signal (Nominal): 10 MHz, +0 dBm

Output impedance (Nominal): 50 Ω

The seal showing the serial number of the product.

The label showing the information of the "Certificate of Authenticity."

A USB (Universal Serial Bus) port (number of ports: 2) specifically installed for an ECal

(Electronic Calibration), a USB/GPIB interface, a multiport test set or a printer. The

specifications of this port are identical to the "12. Front USB Port" on page 39.

These two ports are not available for connections.

A 25-pin parallel port for printer connection. Connecting a designated printer to this port

allows screen information on the E5070B/E5071B to be printed. For more on printing, see

"Printing Displayed Screen" on page 369.

A port to which a mini-DIN type keyboard is connected. The keyboard can be used to edit

VBA programs inside the E5070B/E5071B or to enter file names. Since the arrow keys and

numeric keys on the keyboard work in the same way as the arrow keys and numeric keys

on the front panel of the E5070B/E5071B, you can use it instead of front panel operation.

Be sure to only use a keyboard designated for use with this instrument. Using a keyboard

other than those designated may cause erroneous input.

E5070b E5071b