Operational Procedure (When Using Ecal Module) - Agilent Technologies ENA Series User Manual

Calibration
Scalar-Mixer Calibration
Figure 4-77 Connection of power sensor
Step 28. Press
Step 29. Press
Step 30. Press
Step 31. Press
Step 32. Press
Step 33. Press
to be calculated, turning on the error correction function automatically.

Operational procedure (when using ECal module)

To start calibration, refer to "Operational Procedure (when using mechanical calibration
kit)" on page 235; the steps up to Step 7 in that procedure are common to this procedure.
Step 1. Select a test port and then press
NOTE In scalar-mixer calibration, the power meter is used. For more information on how to set
the power meter, see "Preparing to control the power meter" on page 210.
Step 2. Press
If you are using a one-channel power meter, select Channel A.
Step 3. Connect the power sensor for the selected channel to the selected port, as shown in Figure
4-78.
238
.
Port x@Freq x
.
Port x@Freq y
.
Port y@Freq x
.
Port y@Freq y
.
Return
to exit the scalar-mixer calibration. This step allows the calibration coefficient
Done
. Each time the key is pressed, Channels A and B switch over alternately.
Use Sensor
.
Power Meter
Chapter 4