Selecting Calibration Kit - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Selecting Calibration Kit

Before executing calibration, you need to select a calibration kit.

If you use a calibration kit other than a predefined one, you need to define it. If the

connector type of the standard of the calibration kit you use has polarity (the distinction

between male and female), you need to change the standard class definition of the

calibration kit depending on the standard you actually use. For more information, see

"Changing the Calibration Kit Definition" on page 181.

If you select a predefined calibration kit, (m) and (f) in the name (label) of the standard

displayed in the softkey indicate male (m) and female (f) for the analyzer's connector,

respectively.

Follow these steps to select the calibration kit.

Step 1. Press

calibration kit.

Step 2. Press

Step 3. Press

Step 4. Select the calibration kit from the list below.

If the name (label) of the calibration kit has been changed, the label is displayed as the

An asterisk (*) on the upper right of the softkey corresponding to a predefined calibration

kit indicates that its definition value has been changed from the factory setting by the user.

Selects the calibration kit "85033E"

Selects the calibration kit "85033D"

Selects the calibration kit "85052D"

Selects the calibration kit "85032F"

Selects the calibration kit "85032B"

Selects the calibration kit "85036B/E"

Selects the calibration kit "85031B"

Selects the calibration kit "85050C/D"

Selects the calibration kit "85052C"

Selects the calibration kit "85038A/F/M"

Selects the second user-defined calibration kit "User"

Selecting Calibration Kit

to select the channel for which you want to select the

E5070b E5071b