A25 Handler I/O Board Replacement; Tools Required; Removal Procedure; Replacement Procedure - Agilent Technologies ENA Series Service Manual

A25 Handler I/O Board Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20

Removal Procedure

Refer to Figure 6-7 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 166.
Step 2. Disconnect the flat cable (item 1) from the A25 handler I/O board.
Step 3. Remove the two TORX T10 screws (item 2) fastening the A25 handler I/O board.
Step 4. Slide the A25 handler I/O board.

Replacement Procedure

Step 1. Reverse the order of the removal procedure.
Figure 6-7 A25 Handler I/O Board Removal
Chapter 6
Replacement Procedure
A25 Handler I/O Board Replacement
175