Procedure - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Full 3-Port Calibration

Connecting standards in full 3-port calibration

Procedure

Step 1. Press

calibration.

Step 2. Press

Step 3. Press

Step 4. Press

Step 5. Press

Step 6. Select the test ports on which you will perform full 3-port calibration. (In the procedure

below, the selected test ports are denoted as x, y, and z.)

An asterisk (*) in the upper-right of the softkey indicates that the existing calibration

coefficient will be cleared if you select the test port and execute acquisition of the

Select Ports

Selects test ports 1, 2, and 3

Selects test ports 1, 2, and 4

Selects test ports 1, 3, and 4

Selects test ports 2, 3, and 4

to select the channel for which you want to perform the

E5070b E5071b