To Configure The Break In Smb Port - Agilent Technologies E5900B User Manual

Configuring the Emulation Probe

To configure the Break In SMB port

If you have an emulation probe, but you do not have an emulation
module, use the following table to configure the behavior of the Break
In SMB connector on the front of the emulation probe. Break in will
assert the DE line on the MMC2107 target processor.
When the emulation probe is connected to an emulation module via the
module/probe interconnect cable, this configuration item is always set
to rising for compatibility with intermodule triggering.
If you need to break on a falling edge, either trigger from the logic
analysis system or use the emulation probe without the emulation
module.
Break in configuration
Value Emulation probe Break In
rising The emulation probe will cause a break into
monitor on a rising edge. (Default)
falling The emulation probe will cause a break into
monitor on a falling edge.
off Inputs to Break In will be ignored.
There is a delay of about 400
processor if you have not connected the DE line to the MMC2107 through the
target interface connector (see page 54).
64
s between receiving the edge and stopping the
m
Emulation for the Motorola M•CORE
Built-in command
cf breakin=rising
cf breakin=falling
cf breakin=off