Displaying Bandwidth Test Results - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Displaying Bandwidth Test Results

Test Result for Trace

The test result of the trace will be indicated in the upper-right area of the graph for each

trace, following BWn:. "n" denotes the trace number (see Figure 11-12). The results are

shown as Pass, Wide, Narrow, or >Span (Fail). You can also display the bandwidth value.

For information on how to display the results, see "Turning On/Off Bandwidth Test and

Displaying Results" on page 392.

Figure 11-12

Sample Bandwidth Test Results

Test Results for Channel

If any channel is unsatisfactory, the message will be displayed as shown in Figure 11-2. (It

will be judged as failed if one or more failed traces are found for the limit test, ripple test,

or bandwidth test within the channel.)

You can also specify this On/Off setting from the Fail Sign, which is provided in the limit

test menu and ripple test menu. From the bandwidth test menu, follow the steps below to

turn it on/off.

Step 1. Press

Step 2. Press

Step 3. Press

In addition to the screen, the following features also let you confirm the test results:

Beep notifying the result was unsatisfactory

Bandwidth Limit

. This menu toggles between on and off.

Bandwidth Test

E5070b E5071b