Data Analysis
Analyzing Data on the Trace Using the Marker
Reading the Relative Value From the Reference Point on the Trace
You can convert the marker reading into a relative value from the reference point.
Figure 6-1
Delta marker mode
Converting From a Reference Point to a Relative Value
Step 1. Following Step 1 to Step 5 in "Reading values on the trace" on page 253, place the
reference marker on the point to be used as the reference.
Step 2. Press
With the reference mode turned on, the stimulus values and response values are indicated
in relative values referred to by the position of the reference marker.
Step 3. Following Step 4 to Step 5 in "Reading values on the trace" on page 253, place markers 1
through 9 on the desired points to read the values.
NOTE
Pressing
the currently active marker. The reference mode will then turn on automatically.
256
to turn on the reference mode.
Ref Marker Mode
Marker → Ref Marker
enables you to place the reference marker at the position of
Chapter 6