Agilent Technologies ENA Series User Manual page 596

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Manual Changes

Performing 2-port TRL/LRM calibration

Step 2. Press the

Step 3. Make the through condition for test ports 1 and 2 and press the

Figure A-6). The through measurement is performed, and an asterisk appears at the

Example of performing 2-port TRL/LRM calibration

Step 4. Press the

Step 5. Connect the Reflection standard to test port 1 and press the

reflection measurement is performed, and an asterisk appears at the

Step 6. Connect the Reflection standard to test port 2 and press the

reflection measurement is performed, and an asterisk appears at the

and then a check mark [v] also appears on the

Step 7. Press the

Step 8. Connect the Match standard to test port 1 and press the

measurement is performed, and an asterisk appears at the

Step 9. Connect the Match standard to test port 2 and press the

measurement is performed, and an asterisk appears at the

check mark [v] also appears on the

Step 10. Press the

Step 11. Connect the Line 1 standard between test ports 1 and 2 and press the

button (1 in Figure A-6).

button and then a check mark [v] also appears on the

button (3 in Figure A-6).

button (4 in Figure A-6).

button (5 in Figure A-6).

[ ]Reflection1

[ ]Reflection2

button (2 in

[ ]Reflection1

[ ]Reflection2

button. The match

button. The reflection

button and then a

[ ]Line1 1-2

Troubleshooting

E5070b E5071b