Sweep Function - Agilent Technologies ENA Series User Manual

Table F-2 Test Port Output Power Levels
Function
Output power levels
Output power ranges

Sweep Function

The list (segment) sweep function enables you to perform measurements corresponding to
two or more sweep conditions in one sweep operation and is supported both on the 8753ES
and E5070B/E5071B. While the 8753ES allows only up to 30 segments per table to be
defined, the E5070B/E5071B allows up to 201 segments to be defined. Furthermore, while
two or more commands are needed to create a table using GPIB (SCPI) commands on the
8753ES, only one command does the same function on the E5070B/E5071B.
The 8753ES supports an IF bandwidth up to 6 kHz, but the E5070B/E5071Bsupports an IF
bandwidth up to 100 kHz, enabling faster sweep operations than with the 8753ES.
While the 8753ES supports automatically selecting the output power range, the
E5070B/E5071B supports only manual selection.
The 8753ES allows you to measure frequency conversion device such as a mixer; since it
supports the frequency offset sweep. The E5070B/E5071B also supports this function
when the option 008 is used.
Appendix F
Replacing the 8753ES with the E5070B/E5071B
Important Functional Differences
8753ES
−85 dBm to 10 dBm (std.)
−85 dBm to 8 dBm
(Options 014 and 075)
−15 dBm to 10 dBm (std.) or
−15 dBm to 8 dBm
(Options 014 and 075),
−25 dBm to 0 dBm,
−35 dBm to −10 dBm,
−45 dBm to −20 dBm,
−55 dBm to −30 dBm,
−65 dBm to −40 dBm,
−75 dBm to −50 dBm,
−85 dBm to −60 dBm
E5070B/E5071B
−15 dBm to 0 dBm
(Options 213, 313, and 413)
−50 dBm to 0 dBm
(Options 214, 314, and 414)
−15 dBm to 0 dBm only
(Options 213, 313, and 413)
−15 dBm to 10 dBm,
−20 dBm to 5 dBm,
−25 dBm to 0 dBm,
−30 dBm to −5 dBm,
−35 dBm to −10 dBm,
−40 dBm to −15 dBm,
−45 dBm to −20 dBm,
−50 dBm to −25 dBm
(Options 214, 314, and 414)
737