Recall Procedure - Agilent Technologies ENA Series User Manual

Recall Procedure

Follow the procedure below to recall internal data from the E5070B/E5071B.
NOTE If you recall a file that includes traces (its content was set to
was saved), the trigger source is automatically set to Manual.
Step 1. Press
Step 2. Press
Step 3. When you want to recall State01.sta - State08.sta, Autorec.sta
Press
When you want to recall other files
1. Press
box.
2. Select the folder and the file using the external keyboard and mouse.
3. Click
Figure 10-3 Open dialog box
NOTE Do not press the disk eject button while the floppy disk access lamp is on. Trying to
forcefully pull the floppy disk out while the lamp is on may damage the floppy disk or disk
drive.
NOTE When a user file is used in "Extending the Calibration Plane Using Network
De-embedding" on page 285, "Determining Characteristics After Adding a Matching
Circuit" on page 287, or "Determining the Characteristics that Result from Adding a
Matching Circuit to a Differential Port" on page 303 and the setup status is saved, a recall
error will occur if the user file is not located in the same folder as when the state was saved.
Chapter 10
.
.
Recall State
- or
State01 State08 Autorec
to open the Open dialog box. Figure 10-3 illustrates the Open dialog
File Dialog...
.
Open
Saving and Recalling Instrument State
State &Trace
.
Data Output
or when it
All
357