Download  Print this page

Electrical Connectors; Power Supply; Ethernet Interface X1P1 - Siemens CP 1243-1 PCC Operating Instructions Manual

Telecontrol
Hide thumbs

Advertisement

LEDs and connectors

3.3 Electrical connectors

DIAG
(red / green)
Loading firmware
3.3
Electrical connectors
3.3.1

Power supply

Power supply
The CM is supplied with power from the backplane bus. It does not require a separate power
supply.
3.3.2

Ethernet interface X1P1

Ethernet interface
The Ethernet connector is located behind the lower hinged cover of the module. The
interface is an RJ-45 jack according to IEEE 802.3.
The pin assignment and other data relating to the Ethernet interface can be found in the
section Technical specifications (Page 61).
20
LINK
CONNECT
(red / green)
(green)
SERVICE
(green)
Firmware being loaded.
The "DIAG" LED flashes alternating
red and green.
Firmware was successfully loaded.
Errors:
Error loading firmware
Internal error of the CP
remedy: Power OFF → ON
Operating Instructions, 02/2015, C79000-G8976-C384-01
Meaning
CP 1243-1 PCC

Advertisement

Table of Contents
loading

  Related Manuals for Siemens CP 1243-1 PCC

This manual is also suitable for:

Simatic s7-1200