Static Multicast Commands; Static Multicast Commands Summary - ZyXEL Communications IES4005M User Manual

Use these commands to configure static multicast settings.

17.1 Static Multicast Commands Summary

Use static multicast to allow incoming frames based on the VLAN ID and multicast MAC addresses
that you specify.
The following table describes commonly used parameter notation for these commands.
Table 92 Static multicast command parameters
Notation
uni-vlan
mac
This table describes the commands.
Table 93 Static multicast commands summary
Command
interface dsl <slot/portlist>
smcast <mac> uni-vlan <uni-vid>
smcast <mac> uni-untag
no smcast <mac>
show interface dsl <slot/portlist>
smcast
IES4005M User's Guide
C

Static Multicast Commands

Description
The VLAN ID on the UNI (User Network Interface) ports, 1-4093.
This is a static multicast MAC address (01:00:5e:00:00:00 ~ 01:00:5e:7f:ff:ff) which
identifies the multicast group.
Description
Enters the sub-command mode for configuring the specified DSL
ports.
Configures a static multicast group and the VLAN ID that incoming
frames from the multicast group must be tagged with.
Note: Make sure the VLAN is configured in VLANTrunk or VLAN
Translation mode before using this command.
Configures a static multicast group with no VLAN tagged. That is,
the ports only accept untagged frames from the multicast group.
Removes the specified static multicast group.
Displays static multicast settings on the specified DSL ports.
HAPTER
1 7
M P
C 13
C 13
C 13
C 13
E 13
139