Subaru Legacy 2004 Service Manual page 2434

AUTOMATIC TRANSMISSION
33.Oil Pump Cover
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-71, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the oil charge pipe. <Ref. to 5AT-70,
REMOVAL, Oil Charge Pipe.>
5) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-60, REMOVAL, ATF Filter.>
6) Separate the converter case and transmission
case part. <Ref. to 5AT-84, REMOVAL, Converter
Case.>
7) Remove the oil pump cover aligning bolt, and
then separate it from the AT main case by lightly
tapping with plastic hammer.
B: INSTALLATION
1) Secure the oil pump cover.
Tightening torque:
!
41 N m (4.2 kgf-m, 30.4 ft-lb)
2) Install the converter case assembly into trans-
mission case assembly. <Ref. to 5AT-71, INSTAL-
LATION, Torque Converter Assembly.>
3) Install the transmission harness connector to the
stay.
4) Install the ATF filter pipe. <Ref. to 5AT-60, IN-
STALLATION, ATF Filter.>
5) Install the oil charge pipe with O-ring. <Ref. to
5AT-70, INSTALLATION, Oil Charge Pipe.>
Oil Pump Cover
6) Install the torque converter assembly. <Ref. to
5AT-71, INSTALLATION, Torque Converter As-
sembly.>
7) Install the transmission assembly into vehicle.
<Ref. to 5AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. FRONT BRAKE
1) Remove the snap ring.
2) Remove the retainer plate, drive plate and driven
plate.
3) Remove the snap ring using ST1, ST2 and ST3.
ST1 18762AA000 COMPRESSOR SPECIAL
ST2 18765AA000 COMPRESSOR SUPPORT
ST3 18763AA000 COMPRESSOR SHAFT
AT-01976
4) Remove the retainer and return spring.
5) Remove the front brake piston by blowing com-
pressed air.
AT-01976
6) Remove the D-ring from front brake piston.
5AT-86
TOOL
ST2
ST3
AT-01980
ST1
AT-01981
AT-02349