Subaru Legacy 2004 Service Manual page 2450

AUTOMATIC TRANSMISSION
ST3 18763AA000 COMPRESSOR SHAFT
ST3
4) Install the dish plate.
NOTE:
When installing, make sure that the identification
mark is facing the front side of transmission.
5) Install the drive plate and driven plate.
6) Install the leaf spring.
(A)
B'
(A)
(A) Leaf spring
7) Install the retaining plate.
AT Main Case
ST1
ST2
AT-02000
B
B' B
AT-01999
8) Install the snap ring of reverse brake.
9) Perform the clearance check of reverse brake.
(1) Measure the clearance between retainer
plate and snap ring using thickness gauge.
Standard value:
0.7 — 1.1 mm (0.028 — 0.043 in)
(2) If the clearance is out of specification, select
a suitable retainer plate from following table and
assemble it.
Part Number
31567AB100
31567AB170
31567AB180
31567AB190
31567AB200
10) Install the direct clutch assembly.
5AT-102
AT-01998
AT-02372
Retainer plate
Thickness mm (in)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
4.8 (0.189)
5.0 (0.197)
AT-01997