Subaru Legacy 2004 Service Manual page 2443

2) Secure the case in a vise and remove the hypoid
driven gear tightening bolts, then separate the hy-
poid driven gear case (RH) and case (LH).
(A) Hypoid driven gear
(B) Differential case (RH)
(C) Differential case (LH)
3) Pull out the straight pin and shaft, and then re-
move the differential bevel gear, washer and differ-
ential bevel pinion.
(A) Differential case (RH)
2. SIDE RETAINER
NOTE:
After adjusting the drive pinion backlash and tooth
contact, remove and install the oil seal and O-ring.
1) Remove the O-ring.
Front Differential
(A)
(B)
(C)
AT-00217
(A)
AT-00218
AT-00219
5AT-95
AUTOMATIC TRANSMISSION
2) Remove the oil seal.
3) Remove the split pin, and then remove the claw.
ST 398527700 PULLER ASSY
(A) Claw
(B) Split pin
(C) Pin
4) Attach two claws to the outer race, and set the
ST to side retainer.
ST 398527700 PULLER ASSY
(A) Shaft
(B) Claw
5) Restore the removed claws to original position,
and install the pin and split pin.
6) Hold the shaft of ST to avoid removing from side
retainer, and then remove the bearing outer race.
ST 398527700 PULLER ASSY
AT-00220
AT-00221
AT-00222