Subaru Legacy 2004 Service Manual page 2432

AUTOMATIC TRANSMISSION
32.Converter Case
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the torque converter assembly. <Ref. to
5AT-71, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the turbine speed sensor 1. <Ref. to
5AT-57, REMOVAL, Turbine speed sensor 1.>
5) Remove the oil charge pipe. <Ref. to 5AT-70,
REMOVAL, Oil Charge Pipe.>
6) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-60, REMOVAL, ATF Filter.>
7) Remove the converter case aligning bolt.
8) Lay along the transmission body, and then re-
move the oil pan.
9) Remove the three converter case aligning bolts
®
(TORX ).
ST 18676AA020 TORX
10) Separate the converter case by lightly tapping
with plastic hammer.
11) Remove the differential assembly. <Ref. to
5AT-94, REMOVAL, Front Differential.>
12) Remove the oil seal from converter case.
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER
ST
Converter Case
®
WRENCH
AT-01974
AT-01979
5AT-84
3) Install the differential assembly to case. <Ref. to
5AT-94, INSTALLATION, Front Differential.>
4) Install the left and right side retainers. <Ref. to
5AT-97, ADJUSTMENT, Front Differential.>
5) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
6) Install the converter case assembly without
damaging bushing and oil seal.
Tightening torque:
!
41 N m (4.2 kgf-m, 30.4 ft-lb)
7) Install the three converter case aligning bolts
®
(TORX ).
ST 18676AA020 TORX
Tightening torque:
!
41 N m (4.2 kgf-m, 30.4 ft-lb)
8) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface, and then install it.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
AT-01975
®
WRENCH
AT-01974