Subaru Legacy 2004 Service Manual page 2452

AUTOMATIC TRANSMISSION
16) Install the thrust needle bearing of middle carri-
er assembly.
17) Measure the total end play, and select the
bearing. <Ref. to 5AT-106, ADJUSTMENT, AT
Main Case.>
18) Install the impact clutch pack assembly to oil
pump cover.
(B)
(A) Impact clutch pack ASSY
(B) Front sun gear ASSY
19) Turn the transmission sideways.
20) Install the oil pump cover.
(1) Apply ATF to the O-ring of input clutch shaft.
(2) Install the oil pump cover to AT main case
while supporting the input clutch shaft and oil
pump housing by hand.
AT Main Case
AT-01991
(A)
AT-02006
AT-01990
5AT-104
(3) Make sure the rear end of drive pinion shaft
is engaged to the spline of reduction driven
gear.
(A)
(A) Drive pinion shaft
(4) Using a cloth, protect the input clutch shaft
and rotate to engage the spline of input clutch
and rear carrier using pliers.
NOTE:
Work with pressing oil pump cover.
(A) Cloth
(5) Combine the oil pump cover with transmis-
sion main case.
Tightening torque:
!
41 N m (4.2 kgf-m, 30.4 ft-lb)
21) Install the center differential carrier. <Ref. to
5AT-80, INSTALLATION, Center Differential Carri-
er.>
22) Install the reduction driven gear. <Ref. to 5AT-
78, INSTALLATION, Reduction Driven Gear.>
AT-02092
(A)
AT-02046
AT-01976