Front Panel Tap Interfaces - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
hostname
Default
The default is None.
Command Mode
Privileged EXEC

Front Panel TAP Interfaces

The commands in this section can be used to enable and monitor the FPTI mode.
4-162 fpti
This command is used to enable the FPTI mode either globally (Global Config mode) or for a specific
interface (Interface Config mode).
The no command is used to disable the FPTI mode.
fpti
no fpti
Parameters
None
Default
The default is Enabled.
Command Mode
•
Global Config
•
Interface Config
4-163 show port fpti
This command is used to display the global FPTI mode, as well as the FPTI mode on all the interfaces. If
a single interface is specified, then only the FPTI mode for that interface will be displayed.
show port fpti [slot/port]
Indicates the system prompt, up to 64 case sensitive characters.
133