D-Link 5000 Series Cli Reference Manual page 457

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Remote port mirroring is configured through the RSPAN VLAN ID. At the source switch the destination is
configured as RSPAN VLAN and at the destination switch the source is configured as RSPAN VLAN.
Note: Source and destination cannot be configured as a remote on the same device.
No command disables the selected port mirroring session.
monitor session session-id mode
no monitor session session-id mode
Parameters
session-id
Default
The default is None.
Command Mode
Global Config
5-408 no monitor session
Configure the monitor session (port monitoring) designation from the source probe port, the destination
monitored port and all VLANs. Once removed from the VLAN, a port must be added manually to the
desired VLAN. Use the source interface slot/port parameter or destination interface to remove the
specified interface from the port monitoring session. Use the mode parameter to disable the
administrative mode of the session.
no monitor session session-id { destination[interface slot/port] | remote vlan} | filter {ip | mac } |
mode | source }
Parameters
session-id
destination
interface slot/port
remote
vlan
Filter ip / mac
mode
source
Indicates the session ID number (1 – 4).
Indicates the session number (1 – 4).
Configure the probe interface.
Enter an interface in slot/port format.
Configure source as remote.
Configure monitoring on the VLAN.
Configure filter.
Enable/Disable port mirroring session.
Configure the source interface.
451