D-Link 5000 Series Cli Reference Manual page 990

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
9-63 show ip igmp-proxy groups
Shows information regarding the subscribed multicast groups that the IGMP Proxy has reported. The
command will cause a table of entries with the following parameters given as the fields of each column to
be displayed.
show ip igmp-proxy groups
Parameters
None
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show ip igmp-proxy groups
Interface Index.................................. 0/1
Group Address Last Reporter
------------- -------------
225.4.4.4 5.5.5.48
226.4.4.4 5.5.5.48
227.4.4.4 5.5.5.48
228.4.4.4 5.5.5.48
Display Parameters
Interface
Group Address
Last Reporter
Up Time (in secs)
Member State
Up Time Member State
---------- -------------
00:02:21 DELAY_MEMBER
00:02:21 DELAY_MEMBER
00:02:21 DELAY_MEMBER
00:02:21 DELAY_MEMBER
The interface number of the IGMP Proxy.
The IP address of the multicast group.
The IP address of host that last sent a membership report for the current
group on the network attached to the IGMP Proxy interface (upstream
interface).
The time elapsed since last created.
The status of the entry. Possible values are IDLE_MEMBER or
DELAY_MEMBER
•
IDLE_MEMBER – interface has responded to the latest group
membership query for this group.
•
DELAY_MEMBER – interface is going to send a group
membership report to respond to a group membership query for
this group.
984
Filter Mode Sources
------------ ----------
Include 3
Include 3
Exclude 0
Include 3