D-Link 5000 Series Cli Reference Manual page 634

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Display Parameters
Tenant ID
Tenant MAC
VTEP
Interface
Applflndex
Entry Type
6-59 show vxlan vtep
This command is used to show the status of the remote VTEPs included in a given VXLAN virtual network.
show vxlan vnid vtep [ip-address]
Parameters
vnid
ip-address
Default
The default is None.
Command Mode
Privileged EXEC
Example
(Routing)(Config)#show vxlan 1 vtep
Remote VTEP Dest UDP Port
--------------- ---------------
20.20.20.1 4789
200.200.200.1 4789
(Routing)(ConFig)#show vxlan 1 vtep 20.20.20.1
VXLAN ID......................................... 1
Remote VTEP...................................... 20.20.20.1
Destination UDP Port............................. 4789
Reachable........................................ NO
Virtual Subnet ID (VSID).
MAC address of a host or tenant system.
IP address of the VTEP if the tenant system is behind the remote VTEP.
This is valid for the remote tenant system, otherwise it is blank.
Access interface on which the MAC entry is learned or configured. This
valid for the tenant system on the local access interface, otherwise it is
blank.
lnternal access or tunnel port handle.
Configured or learned.
Indicates VXLAN VNID.
(Optional) Indicates an IP address identifier of tenant system.
Uptime (sec)
------------
0
0
628
Reachable Reachable Transitions
--------- ----------------------
NO 0
NO 0