Using The No Form Of A Command - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Slot Type
Logical slot numbers
CPU slot numbers
For a given slot, the port refers to the specific physical port or logical interface being managed on the slot.
Table 4: Types of Ports
Port Type
Physical Ports
Logical Interfaces
CPU ports
Note: In the CLI itself, the
instead to specify a loopback interface.

Using the No Form of a Command

The keyword is used to form the negative form of an existing command and is not a new or distinct
no
command itself. A
command is used to reverse the action of the command or to reset a given value back to its default. For
example, the
Alternatively, a given command can be used without the
feature or to enable a feature that is disabled by default. The
configuration commands.
Description
Logical slots numbers are given immediately after physical slot numbers and
identify port-channel (LAG) or router interfaces. The values for logical slot
numbers are dependent upon the type of logical interface and can differ from
platform to platform.
The CPU slot numbers are given immediately after the logical slot numbers.
Description
Starting from zero, the physical ports for each slot are numbered in sequence.
Port-channel or Link Aggregation Group (LAG) interfaces consist of logical
interfaces that are used for bridging functions only.
VLAN routing interfaces consist of logical interfaces that are used for routing
functions only.
Loopback interfaces consist of logical interfaces that are constantly up.
Tunnel interfaces consist of logical point-to-point links in which encapsulated
packets are carried.
CPU ports consist of ports that are handled by the driver and are physical
entities that are located in physical slots.
slot/port
form exists for almost every configuration command. in general, the
no
shutdown configuration command is used to reverse the shutdown of an interface.
no
format is not used for loopback interfaces. Use the loopback ID
keyword to reenable a previously disabled
no
no
10
form is only available for the
form of a
no