D-Link 5000 Series Cli Reference Manual page 289

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
no sdm prefer
Parameters
dual-ipv4-and-ipv6 alpm
dual-ipv4-and-ipv6 data-
center
dual-ipv4-and-ipv6 dcvpn-
data-center
dual-ipv4-and-ipv6 default
ipv4-routing alpm
ipv4-routing data-center
default
ipv4-routing data-center
plus
ipv4-routing dcvpn-data-
center
ipv4-routing default
Default
The default is ipv4-routing data-center plus.
Command Mode
Global Config
5-186 show sdm prefer
Use this command to view the currently active SDM template and its scaling parameters, or to view the
scaling parameters for an inactive template. When invoked with no optional keywords, this command lists
the currently active template and the template that will become active on the next reboot, if it is different
from the currently active template. lf the system boots with a non-default template, and you clear the
template configuration, either using no sdm prefer or by deleting the startup configuration, show sdm
prefer lists the default template as the next active template. To list the scaling parameters of a specific
template, use that template's keyword as an argument to the command.
Use the optional keywords to list the scaling parameters of a specific template.
show sdm prefer [dual-ipv4-and-ipv6 {default | data-center | alpm | data-center | dcvpn-data-
center| default} | ipv4-routing {default | data-center {default | plus}}]
Lists the scaling parameters for the the Dual IPv4 and IPv6 alpm
template supporting more IPv4 unicast routes.
List the scaling parameters for the Dual IPv4 and IPv6 template
supporting more ECMP next hops entries than dcvpn-data-center.
List the scaling parameters for the Dual IPv4 and IPv6 template
supporting less ECMP next hops entries than data-center.
List the scaling parameters for the the Dual IPv4 and IPv6 default
template supporting balance IPv4 and IPv6 entries.
List the scaling parameters for the IPv4-only template supporting more
IPv4 routes.
List the scaling parameters for the IPv4-only template maximizing the
number of unicast routes and also supporting more ARP entries in IPv4
routes.
List the scaling parameters for the IPv4-only template maximizing the
number of ARP entries and IPv4 routes.
List the scaling parameters for the IPv4-only template maximizing the
number of MAC address entries.
List the scaling parameters for the IPv4-only template supporting the
default setting.
283