D-Link 5000 Series Cli Reference Manual page 94

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
The no command is used to disable Multiple User traps.
snmp-server enable traps multiusers
no snmp-server enable traps multiusers
Parameters
None
Default
The default is Enabled.
Command Mode
Global Config
4-99 snmp-server enable traps stpmode
This command is used to enable the sending of both new root traps and topology change notification
traps.
The no command is used to disable the sending of both new root traps and topology change notification
traps.
snmp-server enable traps stpmode
no snmp-server enable traps stpmode
Parameters
None
Default
The default is Enabled.
Command Mode
Global Config
4-100 snmp-server enginelD local
This command is used to configure the SNMP engine ID on a local device.
The no command is used to remove the specified engine ID.
CAUTION: If the engine lD is changed, all the SNMP configurations that exist on the box will be
invalidated.
snmp-server enginelD local {engine-id | default}
88