D-Link 5000 Series Cli Reference Manual page 477

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
5-439 ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
Use the no command to remove the IPSG static entry from the IPSG database.
ip verify binding mac-address vlan vlan-id ip address interface interface-id
no ip verify binding mac-address vlan vlan-id ip address interface interface-id
Parameters
mac-address
vlan vlan-id
ip address
interface interface-id
Default
The default is None.
Command Mode
Global Config
5-440 ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come on an interface or
range of interfaces. By default, rate limiting is disabled. When enabled, the rate can range from 0 to 300
packets per second. The burst level range is 1 to 15 seconds.
Use the no command to set the rate at which the DHCP Snooping messages come, and the burst level,
to the defaults.
ip dhcp snooping limit {rate pps [burst interval seconds]}
no ip dhcp snooping limit
Parameters
pps
seconds
Default
The default is Disabled (no limit).
Enter MAC address.
Indicates the VLAN ID.
Indicates the IP address for the location.
Indicates the interface to specify.
Enter rate in the range <0-300> pps.
(Optional) Enter burst interval in the range <1-15> seconds.
471