D-Link 5000 Series Cli Reference Manual page 38

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
show serviceport ipv6 neighbors
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following provides an example of the command
(Routing) #show serviceport ipv6 neighbors
IPv6 Address
-----------------------
FE80::5E26:AFF:FEBD:852C
Display Parameters
IPv6 Address
Type
MAC Address
isRtr
Neighbor State
Age
4-21 show network ipv6 dhcp statistics
This command is used to show the statistics for the DHCPv6 client running on the network management
interface.
show network ipv6 dhcp statistics
Type MAC Address
-------- ----------------- ------
Dynamic 00:09:e7:00:00:50 True
Indicates the IPv6 address of the neighbor.
Indicates the type of neighbor entry. If the entry is manually configured,
the type is Static; if the entry is dynamically resolved, the type is
Dynamic.
Indicates the MAC Address of the neighbor.
Indicates whether or not the neighbor is a router. If TRUE, the neighbor
is a router; if FALSE, the neighbor it is not a router.
Indicates the state of the neighbor cache entry. The possible values are
as follows: Incomplete, Reachable, Stale, Delay, Probe, and Unknown.
Indicates the time (in seconds) that has elapsed since the most recent
entry was added to the cache.
32
Neighbor Age
isRtr State (Secs)
----- -------
Stale 3