D-Link 5000 Series Cli Reference Manual page 98

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
snmp-server port 1025-65535
no snmp-server port
Parameters
None
Default
The default is 161.
Command Mode
Privileged EXEC
4-105 snmp-server trapsend
This command is used to set the UDP port that the SNMP server sends traps too.
The no command is used to send traps to the default UDP port.
snmp-server trapsend portid
no snmp-server trapsend portid
Parameters
None
Default
The default is 50505.
Command Mode
Global Config
4-106 snmp-server user
This command is used to create an SNMPv3 user to whom access to the system is granted.
The no command is used to remove the specified SNMPv3 user.
snmp-server user username groupname [remote engineid-string] [{auth-md5 password | auth-sha
password | auth-md5-key md5-key | auth-sha-key sha-key} [priv-des password | priv-des-key des-
key]
no snmp-server user username
92