5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
sourceipaddr
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show ip mroute static
Source IP
Source Mask
---------------
----------
1.1.1.1
255.255.255.0
Display Parameters
Source IP
Source Mask
RPF Address
Preference
9-12
clear ip mroute
Deletes all of the multicast route entries or specified IP multicast route entries.
Note: It should be noted that this command clears only dynamic mroute entries; static mroute entries will
not be cleared by it.
clear ip mroute {* | group-address [source-address]}
Parameters
*
group-address
source-address
(Optional) Indicates the source IP address.
MULTICAST STATIC ROUTES
RPF Address
----------
2 2 2.2
IP address of the multicast source network.
The subnetwork mask pertaining to the source IP.
The IP address of the RPF next-hop router toward the source.
The administrative distance for this Static MRoute.
Deletes all IPv4 entries from the IP multicast routing table.
IP address of the multicast group.
(Optional) The IP address of a multicast source that is sending multicast
traffic to the group.
943
Preference
----------
23