D-Link 5000 Series Cli Reference Manual page 590

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
6-10 qcn cnpv-priority cp-creation
The qcn cnpv-priority cp-creation command is used in the Global Configuration mode to globally
configure the default scope of the per port-priority defense mode choice that is made whenever a CP is
newly created. The default scope in question can be admin or component.
qcn cnpv-priority cnpv-priority cp-creation {enable | disable}
Parameters
cnpv-priority
enable
disable
Default
The default is Enabled for qcn cp-creation.
Command Mode
Global Config
6-11 qcn cnpv-priority defense-mode-choice
The qcn cnpv-priority defense-mode-choice command is used in the lnterface Configuration mode to
choose admin or component as the defense mode of an interface, that is, to choose whether the
interior/edge/disable and alternate priorities will use the per-priority configuration or per-port-priority
configuration.
qcn cnpv-priority cnpv-priority defense-mode-choice {admin | component}
Parameters
cnpv-priority
admin
component
Default
The default is Enabled.
Command Mode
Interface Config
The range is 0-7.
If cp-creation is enabled, the per-port defense mode choice is set to
component
If cp-creation is disabled, the per-port defense mode choice is set to
admin.
The range is 0-7.
Per priority.
Per priority level configuration.
584