D-Link 5000 Series Cli Reference Manual page 774

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default Route Advertise........................ Disabled
Always......................................... False
Metric......................................... Not configured
Metric Type.................................... External Type 2
Number of Active Areas........................... 1 (1 normal, 0 stub, 0 nssa)
ABR Status....................................... Disable
ASBR Status...................................... Disable
Stub Router...................................... FALSE
Stub Router Status............................... Inactive
Stub Router Reason............................... <reason>
Stub Router Startup Time Remaining............... <duration> seconds
Stub Router Duration............................. <duration>
External LSDB Overflow........................... FALSE
External LSA Count............................... 0
External LSAChecksum............................. 0
AS_OPAQUE LSA Count.............................. 0
AS_OPAQUE LSA Checksum........................... 0
New LSAs Originated.............................. 55
LSAs Received.................................... 82
LSA Count........................................ 1
Maximum Number of LSAs........................... 24200
LSA High water Mark.............................. 9
AS Scope LSA Flood List Length................... 0
Retransmit List Entries.......................... 0
Maximum Number of Retransmit Entries............. 96800
Retransmit Entries High water Mark............... 1
NSF Helper Support............................... Always
NSF Helper Strict LSA Checking................... Enabled
Prefix-suppression............................... Disabled
Display Parameters
Note: Some of the information below displays only if you enable OSPF and configure certain features.
Router ID
OSPF Admin Mode
RFC 1583 Compatibility
External LSDB Limit
Exit Overflow Interval
Spf Delay Time
Spf Hold Time
Flood Pacing Interval
32-bit integer in dotted decimal format identifying the router, about which
information is displayed.
Shows whether the administrative mode of OSPF in the router is
enabled or disabled.
Indicates whether 1583 compatibility is enabled or disabled.
Maximum number of nondefault AS-external-LSA (link state
advertisement) entries that can be stored in the link-state database.
Number of seconds after entering overflow state that a router will
attempt to leave overflow state.
Number of seconds between two subsequent changes of LSAs, during
which time the routing table calculation is delayed.
Number of seconds between two consecutive SPF calculations.
Average time, in milliseconds, between LS Update packet transmissions
768