D-Link 5000 Series Cli Reference Manual page 266

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default is None.
Command Mode
Global Config
5-160 exception protocol
Specify the protocol to store the core dump file.
No command resets the exception protocol configuration to factory default.
exception protocol {nfs | tftp | ftp | local | none}
no exception protocol
Parameters
nfs
tftp
ftp
local
none
Default
The default is None.
Command Mode
Global Config
5-161 exception switch-chip-register
This command enables or disables the switch-chip-register dump in case of an exception. The switch-
chip-register dump is taken only for a master unit and not for member units.
exception switch-chip-register {enable | disable}
Parameters
enable
disable
Configure protocol to upload coredump to the NFS share.
Configure protocol to upload coredump to the TFTP server.
Configure protocol to upload coredump to the FTP server.
Configure protocol to generate coredump on Switch local file system.
Disable coredump.
Enable switch-chip-register dump in case of an exception.
Disable switch-chip-register dump in case of an exception.
260