D-Link 5000 Series Cli Reference Manual page 690

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
7-60 match length
Configure a route map to match based on the Layer 3 packet length between specified minimum and
maximum values. min specifies the packet's minimum Layer 3 length, inclusive, allowed for a match. max
specifies the packets maximum Layer 3 length, inclusive, allowed for a match. Each route-map statement
can contain one 'match' statement on packet length range.
No command deletes a match statement from a route map.
match length min max
no match length
Parameters
min
max
Default
The default is None.
Command Mode
Route Map Config
Example
The following shows an example of the command.
(Routing)(config-route-map)#match length 64 1500
7-61 match mac-list
Configure a route map in order to match based on the match criteria configured in a MAC access-list.
A MAC ACL is configured before it is linked to a route-map. Actions present in MAC ACL configuration
are applied with other actions involved in route-map. When a MAC ACL referenced by a route-map is
removed, the route-map rule is also removed and the corresponding rule is not effective. When a MAC
ACL referenced by a route-map is removed or rules are added or deleted from that ACL, the configuration
is rejected.
No command deletes a match statement from a route map.
match mac-list mac-list-name [mac-list-name...]
no match mac-list mac-list-name [mac-list-name...]
Enter minimum length of the packet greater than or equal to 68.
Enter maximum length of the packet less than or equal to 9198
684