5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
show ip ospf abr [vrf vrf-name]
Parameters
vrf vrf-name
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is an example of the CLI display output for the command.
(Router) #show ip ospf abr
Type
Router Id
-----
---------------
Intra
192.168.1.14
Display Parameters
Type
Router ID
Cost
Area ID
Next Hop
Next Hop lntf
7-185 show ip ospf area
Display information about the area for the specified virtual router. If no router is specified, it displays
information for the default router. The areaid identifies the OSPF area that is being displayed.
show ip ospf area areaid [vrf vrf-name]
(Optional) Display the OSPF Area Border Routers information of a
virtual router.
Cost
Area ID
Next Hop
----- ----------
---------------
100
1
192.168.2.1
Type of route to the destination:
•
intra – intra-area route
•
inter – Inter-area route
Router ID of the destination.
Cost of using this route.
The area ID of the area from which this route is learned.
Next hop toward the destination.
Outgoing router interface to use when forwarding traffic to the next hop.
771
Next Hop Intf
---------------
0/1