D-Link 5000 Series Cli Reference Manual page 80

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
4-75 enable password
The enable password configuration command is used to set a local password in order to control access
to the privileged EXEC mode.
The no command is used to remove the password requirement.
enable password
no enable password
Parameters
password
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an example of the command.
(Routing)#enable password testtest
(Routing)#enable password
e8d63677741431114f9e39a853a15e8fd35ad059e2e1b49816c243d7e08152b052eafbf23b528d348cdba1
b1b7ab91be842278e5e970dbfc62d16dcd13c0b864 encrypted
(Routing)#enable password
Enter old password: ********
Enter new password: ********
Confirm new password: ********
4-76 passwords min-length
This command is used to enforce a minimum password length for local users, with the value used also
applying to the enable password. The range of valid values is 0-64.
The no command is used to reset the minimum password length to the default value.
passwords min-length 0-64
no passwords min-length
Indicates the password string, which must be 8-64 characters in length.
74