D-Link 5000 Series Cli Reference Manual page 216

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
source
hostname
ipv6
interface
link-local-address
outgoing-interface
Defaulta
The default is as follows:
•
Count: 1
•
Interval: 3 seconds
•
Size: 0 bytes
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following provide examples of the CLI command.
The following are examples of ping success:
(Routing)#ping 10.254.2.160 count 3 interval 1 size 255
Pinging 10.254.2.160 with 255 bytes of data:
Received response for icmp_seq = 0. time = 275268 usec
Received response for icmp_seq = 1. time = 274009 usec
Received response for icmp_seq = 2. time = 279459 usec
----10.254.2.160 PING statistics----
3 packets transmitted, 3 packets received, 0% packet loss
round-trip (msec) min/avg/max = 274/279/276
The following are examples of ping failure:
In Case of Unreachable Destination:
for the payload of the transmitted Echo Requests (range: 0 to 65507
bytes).
The source parameter can be used to specify the source IP/IPv6
address or interface to be used when the Echo request packets are
sent.
The hostname parameter can be used to resolve the hostname to an
IPv4 or IPv6 address. To resolve the hostname to an IPv6 address, the
Ipv6 keyword is specified. If no keyword is specified, then the hostname
is resolved to an IPv4 address.
Using the ipv6 optional keyword, which can be used before either the
ipv6-address or hostname argument, before the hostname will attempt
to resolve the hostname directly to the IPv6 address. The keyword cab
also be used to ping a link-local IPv6 address.
The interface keyword can be used to ping a link-local IPv6 address
over an interface.
Indicates the link-local IPv6 address that is to be pinged over an
interface.
(Optional) The outgoing-interface parameter can be used to specify the
outgoing interface for a multicast lP/lPv6 ping.
210