D-Link 5000 Series Cli Reference Manual page 377

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Command Mode
Privileged EXEC
Example
The following is a CLI display output example for the command show dot1x summary 0/1.
(Routing)#show dot1x summary 0/1
Interface Control Mode
---------- ---------------
0/1 auto
The following shows example CLI display output for the command.
(Routing)#show dot1x detail 0/1
Port............................................. 0/1
Protocol Version................................. 1
PAE Capabilities................................. Supplicant
Control Mode..................................... auto
Supplicant PAE State............................. Initialize
Supplicant Backend Authentication................ Initialize
Maximum Start trails............................. 3
Start Period (secs).............................. 30
Held Period (secs)............................... 60
Authentication Period (secs)..................... 30
EAP Method....................................... MD5-Challenge
Display Parameters
Global dot1x, VLAN Assignment, and Dynamic VLAN Creation mode are displayed if optional slot/port or
vlanid parameters are defined.
Administrative Mode
VLAN Assignment Mode
Dynamic VLAN Creation
Mode
Monitor Mode
By using the summary parameter {slot/port | all}, the dot1x configuration for the specified port or all ports
is displayed.
Interface
Control Mode
Operating Control Mode
Operating Control Mode
-----------------------
auto
Display enabled or disabled status.
Display enabled or disabled status for an authorized port to a RADIUS-
assigned VLAN.
Indicates support for dynamic creation of RADIUS-assigned VLAN.
Displays Dot1x Monitor mode status: enabled or disabled.
The displayed interface.
Configured control mode, values: force-unauthorized, force-authorized,
auto, mac-based, authorized, and unauthorized.
Displays operating control mode, values: authorized or unauthorized.
371
Port Status
-------------
Authorized