D-Link 5000 Series Cli Reference Manual page 204

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
5-63 logging email logtime
This command is used to configure the frequency with which non-urgent email messages are sent. That
is, non-urgent messages will be collected and sent together in a batch email at the specified interval (valid
range: every 30-1440 minutes).
The no command is used by default to reset the non-urgent log time back to the default value.
logging email logtime 30-1440
no logging email logtime
Parameters
None
Default
The default is 30.
Command Mode
Global Config
5-64 logging traps
This command is used to set the severity level at which SNMP traps are to be logged and sent in an
email. The severitylevel value can be specified as either an integer from 0 to 7 or in a symbolic manner
with one of the keywords that follows: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), and debug (7).
The no command is used to reset the logging severity level for SNMP traps back to the default value.
logging traps severitylevel
no logging traps
Parameters
severitylevel
Default
The default is as follows: messages with a severity level of 6 or higher are logged.
Command Mode
Global Config
Indicates the alert trap severity level.
198