D-Link 5000 Series Cli Reference Manual page 507

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
set igmp querier version 1-2
no set igmp querier version
Parameters
None
Default
The default is 1.
Command Mode
Global Config
5-485 set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping
Querier finds that the other Querier's source address is better (less) than the Snooping Querier's address,
it stops sending periodic queries. If the Snooping Querier wins the election, then it will continue sending
periodic queries.
Use the no command to set the Snooping Querier not to participate in querier election but go into non-
querier mode as soon as it discovers the presence of another querier in the same VLAN.
set igmp querier election participate
no set igmp querier election participate
Parameters
None
Default
The default is Disabled.
Command Mode
VLAN Config
5-486 show igmpsnooping querier
Display IGMP Snooping Querier information. Configured information is displayed whether or not IGMP
Snooping Querier is enabled.
show igmpsnooping querier [{detail | vlan vlanid}]
501