D-Link 5000 Series Cli Reference Manual page 532

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
5-521 lldp receive
Use this command to enable the LLDP receive capability on an interface or a range of interfaces.
Use the no command to return the reception of LLDPDUs to the default value.
lldp receive
no lldp receive
Parameters
None
Default
The default is Disabled.
Command Mode
Interface Config
5-522 lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for LLDP.
The interval-seconds determines the number of seconds to wait between transmitting local data
LLDPDUs. The range is 1-32768 seconds. The hold- value is the multiplier on the transmit interval that
sets the TTL in local data LLDPDUs. The multiplier range is 2-10. The reinit-seconds is the delay before
reinitialization, and the range is 1-0 seconds.
Use the no command to return any or all timing parameters for local data transmission on ports enabled
for LLDP to the default values.
lldp timers [interval interval-seconds] [hold hold-value] [reinit reinit-seconds]
no lldp timers [interval] [hold] [reinit]
Parameters
interval interval-seconds
hold hold-value
reinit reinit-seconds
Default
The default is as follows:
•
Interval – 30 seconds
•
hold – 4
•
reinit – 2 seconds
(Optional) The interval in seconds to transmit local LLDP data.
(Optional) The interval multiplier to set local LLDP data TTL.
(Optional) The delay before re-initialization.
526